• Simple design hence convenient.
• Stronger pump giving efficient performance.
• Uses superior valve design for excellent atomization.
• No need of compressor. Plug in & spray.

• Automobiles   
• Ship/Building

• Code No.                                                         E88
• Cup capacity (litres)                                          1
• Max. Delivery rate(test liquid: water)                  228.6(9)
• Rated Power                                                     65W
• Voltage                                                              220/230V
• Frequency                                                         50Hz
• Pressure Max                                                    150 bar(2,175psi)
• Containor Hold                                                   800 cm3
• Noise Level                                                         90/95 DB
• Weight of gun with cup (gms)                              1.43 kg

• When spraying, keep spray gun in horizontal position or hold spray gun level with the nozzle pointing slightly downwards or slightly upwards. "Crosswise spraying" is the best way of covering a flat surface, using a round jet nozzle. Its important to start off outside the area to be covered and avoid any break during spraying. Move the gun with a steady motion. Slowing down or speeding up will cause irregular spray pattern, spots, runs, irregular finish, ripple effects, etc. Never move the spray gun by flexing your wrist. Instead, swing your whole arm to maintain uniform spacing between spray gun and surface

• Spray vertical surfaces with a thin coat and then apply a second coat to prevent paint runs.
• Spray away from you on horizontal surfaces so that the paint contacts the surface at an angle of about 45 degrees. Any overspray will then be covered up by the next stroke.
• Do not apply too thick a coat in one pass or the paint may run. For best results, spray a thin coat first and allow it to dry, and then apply a second coat.
• Mask off parts which are not to be sprayed with cardboard, masking tape, paper etc. Window frames can be effectively shielded with damp newspaper.
• Ensure that paint is properly thinned.
• The high-pressure produced from the spray gun might lead to injuries. Therefore do not point gun at yourself or in the direction of other people

Fault	Cause	Remedy
Not Sparing	No Pressure at the gun. Needle Adjustment Screw not properly adjusted.	Check Ari Supply. Adjust
Uneven Spray	Material Build up on air Cap/Nozzle Coating material flow or viscosity incorrect.	Clean air cap/nozzle Adjusted needle/screw or reduce viscosity
Intermittent Spray	Insufficient material in cup Gun material passage blocked Loose or damaged nozzle Needle sealing Damage.	Fill Cup Clean Tighten or Replace Replace
Fluid leakage from Packing nut	Needle Packing Damaged	Replace packing.
Dripping from the Nozzle	Damaged Nozzle or needle Foreign substances between fluid tip and needle prevent sealing	Replace Clean needle and nozzle in thinner or replace

The appliance can be operated from single - phase AC supply only. Before starting up, check that mains voltages agrees with operating voltage marked on gun rating plate.